11/20/2012

Specifications - FR107


FR107

High current capability High surge current capability High reliability Low reverse current Low forward voltage drop Fast switching for high efficiency

* Case : DO-41 Molded plastic * Epoxy : UL94V-O rate flame retardant * Lead : Axial lead solderable per MIL-STD-202, Method 208 guaranteed * Polarity : Color band denotes cathode end * Mounting position : Any * Weight : 0.34 gram

Rating 25 °C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%.

Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average Forward Current 0.375"(9.5mm) Lead Length 55 °C Peak Forward Surge Current, 8.3ms Single half sine wave Superimposed on rated load (JEDEC Method) Maximum Peak Forward Voltage = 1.0 Amp. Maximum DC Reverse Current at Rated DC Blocking Voltage 100 °C

Maximum Reverse Recovery Time ( Note 1 ) Typical Junction Capacitance ( Note 2 ) Junction Temperature Range Storage Temperature Range

1 ) Reverse Recovery Test Conditions 1.0 A, Irr 2 ) Measured at 1.0 MHz and applied reverse voltage of 4.0 VDC
FIG.1 - REVERSE RECOVERY TIME CHARACTERISTIC AND TEST CIRCUIT DIAGRAM

NOTES : 1. Rise Time 7 ns max., Input Impedance = 1 megaohm, 22 pF. 2. Rise time 10 ns max., Source Impedance = 50 ohms. 3. All Resistors = Non-inductive Types.
FIG.3 - MAXIMUM NON-REPETITIVE PEAK FORWARD SURGE CURRENT PEAK FORWARD SURGE CURRENT, AMPERES
AMBIENT TEMPERATURE, ( °C) FIG.4 - TYPICAL FORWARD CHARACTERISTICS REVERSE CURRENT, MICROAMPERES

More information, or you can see this:
http://www.hqew.net

No comments:

Post a Comment